Home » Telecommunication » On-Board Networking Solution for Rail-Train, Metro and Tram

On-Board Networking Solution for Rail-Train, Metro and Tram

When train cars are switched, re-configure network settings is normally required. Thus, railway operators need to have enough knowledge of Ethernet. This not only increases the cost of labor but also result in additional time.

Making it flexible for easy maintenance is biggest challenge for on-board network solution.

In most of train application, many train cars will be shifted according to different destination, which often becomes a maintenance issue when any car changes. As the different car devices were set with different IP address that would need to migrate into the same IP without any manual setting to keep the original train network.

Lantech Train Discovery Protocol (LTDP)

With LTDP-aware DHCP server, Lantech EN50155 switches can discover the current IP addresses and enable the switch to exchange the IP address when any car is merged. LTDP can also react on the link failure or node failure to keep the original IP range and maintain the remaining network function until the replacement is in place. It can also keep the config file when switch is swapped.

The video below explains how LTDP works.


Lantech is sure to have the right SWITCH for you!

Take a look at our Lantech EN50155 switches

Posted by on 27. June 2018. Filed under Telecommunication. You can follow any responses to this entry through the RSS 2.0. You can leave a response or trackback to this entry

You must be logged in to post a comment Login


Recent Comments

    © 2021 So-Co-IT. All Rights Reserved. Log in

    - Copyright by LayerMedia

    Blogverzeichnis - Blog Verzeichnis bloggerei.de Blog Top Liste - by TopBlogs.de Bloggeramt.de